Lightspeed Flexmike - CONNECT THE POWER SUPPLY AND CAT 885 AMPLIFIER

13
1. Overview
2. Set Up & Use /
Daily Operation
3. Optional Accessories
4. Maintenance &
Troubleshooting
5. Warranty, Safety
& Specifications
2B. CONNECT THE POWER SUPPLY
1. Plug the micro USB end of the power cable into the USB port on the back of the
Multimike.
2. Plug the other end of the cable into the USB1 power adaptor.
3. The blue power light on the front of the Multimike will light.
REGISTER
USB POWER
5V/0.2A
+
AUDIO IN BAL. AUDIO OUT
AUDIO OUT
MIC LINE
AUDIO OUT/DC IN
USB POWER
5V/1.5A
AUDIO INMICROPHONE TONE
POWER
MIN
1
MAX MIN MAX TREBLE BASS
2
Power Light
2C. OPTIONAL CONNECTION TO LIGHTSPEED
CAT 885 AMPLIFIER
If you are connecting into a new or existing Lightspeed Cat 885 amplifier, you can use Cat
5 cabling to integrate the two components (a 2’ cable is included with the system). This
connection will send the audio from Multimike to the Cat 885 as well as provide power for
the Multimike (no need for an additional AC power connection).
1. Plug one end of the Cat 5 cable into the AUDIO OUT/DC IN jack on the Multimike.
2. Plug the other end into the “SENSOR INPUT” jack on the 885 amplifier.
3. Plug in the Cat 885 into AC power (if it’s not already) and the blue power light on the
front of the Multimike will light.
4. Multimike audio levels can be controlled with the Microphone Volume control on
Multimike as well as the CH A control on the 885 amplifier.
REGISTER
USB POWER
5V/0.2A
+
–
AUDIO IN BAL. AUDIO OUT
AUDIO OUT
MIC LINE
AUDIO OUT/DC IN