16
1. Overview
2. Set Up & Use /
Daily Operation
3. Optional Accessories
4. Maintenance &
Troubleshooting
5. Warranty, Safety
& Specifications
6. OPERATING THE FLEXMIKE
AUDIO INMICROPHONE TONE
POWER
MIN
1
MAX MIN MAX TREBLE BASS
2
Once the Flexmike is charged, follow these steps to set it up for use.
1. Remove the Flexmike from the cradle
charger and put it on by connecting
the magnetic clasps behind your neck.
Adjust the lanyard so that the Flexmike
is at the top of the collarbone
2. The Flexmike will automatically power
on and mute when it is removed from
the charger. This will automatically
power on the Multimike as well.
3. The microphone volume on the
Flexmike is set at the factory to the
mid point.
4. While speaking in a normal voice,
fine-tune the microphone volume on
the front of the Multimike up or down.
Proper volume level should be as
follows:
• Your voice should be clearly heard
by another person on the other
side of the room.
• You should barely be able to hear
your own voice.
• There should not be any audio
“feedback” or squealing outside of
2-3 feet (if there is, turn the volume
down slightly).
REMEMBER: This equipment
supplements the user’s voice so they are
able to speak in a conversational tone.
Having the volume set too high will result
in feedback and listener fatigue.
5. Once initial volume level is set, walk
around the room and listen for overall
audio quality.
6. If further fine-tuning is required, you
may need to adjust the Tone Control
on the front of the Multimike.
.
Up to 5 microphones can be used with a Multimike. This can consist of 5
Flexmikes, 5 Sharemikes or a combination of Flexmikes and Sharemikes for a
total of 5.
To Next Page
Loading...
