10
Pin Mode
- The Electrode E16 consists of two separate posts,
which makes inserting into hard materials easier.
Warning: Test results from pin or pinless meters are not accurate enough to decide
whether or not to lay a wood floor over a concrete slab. An RH in-situ probe test
and/or a Calcium-Chloride test is recommended by most wood floor manufacturers.
See Page 21 for RH in-situ probe test in concrete with the Ligno-VersaTec.
Monitoring using the Ligno-VersaTec
Extension cables and probes can be installed to monitor remote areas, which are
otherwise unreachable. Install probes, connect cable and leave the open cable end
easily accessible. The Ligno-VersaTec can be connected via adapter H, and measure-
ments can be obtained at any time to check for changes in moisture content.
Restoration - Leak Surveillance: An easy way to check the drying progress or to
make sure that a leak is not happening again.
Wood Floor: Metall screws are placed on the
underside of the floor planks or in the subfloor.
Works well during acclimation and for long-
term monitoring after the floor is installed.
Lumber Drying - Air Drying - Storage:
Teflon-coated PK probes and extension cables
are placed inside the lumber stack. This is an
area, which cannot be reached any other way
for pin moisture measurements. Enables you
to measure in the center of the kiln charge
without entering a hot kiln.
Photo shows:
1 Adapter H: connects cable to VersaTec.
2 PK probes for lumber.
3 EG teflon-coated pins and screws.
4 H-Cable with connectors for PK
probes and adapter H.
5 EMC sensor: VersaTec is set up to
show EMC values using EMC sensor.
Lignomat offers everything necessary to monitor and control lumber drying from one-
cable in-kiln monitor to a fully automatic kiln control system. Contact customer ser-
vice at 800-227-2105 to find a solution for your application. See also page 19.
4
1
2
35
e
d
d
e
1
2
3
To Next Page
Loading...