Slide-Hammer Electrode
E12 measures surface
and core up to 2” deep.
Detects a moisture gra-
dient within the board.
Pins: DZ, DA, DB
Drive-in Electrode
E10 shown with EL
pins up to 7” deep.
Pins: EL, EG coated
EV, EA, EC uncoated
Inspector Electrode
E14V, slim to reach
corners. For hard ma-
terials such as bamboo.
Can be extended.
Pins: EL, EG coated
EV, EA, EC uncoated
Specialty Electrode
E16 for hard building
materials (concrete).
Pins: EL, EG coated
EV, EA, EC uncoated
Coated pins:
DZ, DA, DB
up to 2” deep.
For electrode E12
Uncoated pins:
EA, EV, EC
up to 5/8” deep.
electrodes E10, 14, 16.
Calibration Check:
Pin and pinless meters from
Lignomat internally check
and adjust the calibration
before each reading.
Check blocks are used to
confirm calibration and
function of pinless meters
and pin meters, cables,...
Salt solutions are necessary
to check RH BluePeg probes.
More info on pages 23-25.
4
Accessories
Coated pins:
EG up to 3/4” deep
EL up to 7” deep.
electrodes E10, 14, 16
RH cable with
sleeve-seal-plug.
RH adapter.
Thermo-Hygrometer:
add RH BluePeg probe
and adapter to meas-
sure RH/T/DP/GPP.
Sleeves 1.8” and 3” long
for in-situ moisture
testing in concrete.
Sleeve with RH probe
to measure moisture
in wall cavities with
or without insulation.
TS check block for
all Lignomat pinless
meters.
Salt solution to check
RH BluePeg probes,
RH 75%.
RH BluePeg probes.
For concrete test and
relative humidity of air.
TP check block for
all Lignomat pin
meters, cables,...
DZ DA DB
EL EG EC EA EV
To Next Page
Loading...