6
1st
Measuring mode: Pin or scan (pinless).
2nd
Setting for wood and non-wood materials:
# 0-250. Corrections for different wood
species and non-wood materials are needed
in pin and scan mode. Check table below and pocket-guide
for available settings for pin and/or pinless mode.
3rd
Setting for wood temperature: Wood temperature corrections
are only needed in pin mode.
It is difficult to determine the
temperature of the wood at the depth of the pins. Page 7(2).
4th
Setting for measuring depth: 1/4” and 3/4”. Measuring depth
is only used in pinless mode. Page 13.
Before using the Ligno-VersaTec, the active (previously chosen) settings in the meter
need to be checked and if necessary changed to fit the job to be done. To recall active
settings, press the SET/HOLD key repeatedly.
Use up or down keys to change settings:
First Step : Check and Change Settings for Pin / Pinless Mode
SUMMARY OF AVAILABLE WOOD AND MATERIAL SETTINGS PIN SCAN
Settings for moisture measurement of individual wood species 111-230 111-230
Settings for measurement of wood species with known specific gravity - 30-100
Settings for EMC measurements with Lignomat’s EMC sensor 5, 105 -
Settings for wood moisture measurements of wood groups #1-4 101-104 -
#1-4 is used in old Lignometers. #2 and #3 is used in all mini-Lignos 1-4 -
Settings for bamboo, vertical, horizontal, strand and engineered 170-180 11-24*
Settings for moisture measurements of sheetrock and gypsum 15 15
Reference Scale for concrete and other similar materials 25 25
Reference Scale for bldg materials other than concrete or sheetrock 10 10
Reference Scale for laminates and composites made of wood 0 0
*11-24 for bamboo only work on depth setting 1/4”.
See table below: Not all code numbers 0-250 are available for pin and pinless mode.
If the wood or material setting is not available in pin and pinless mode, the meter
will automatically select the available mode. If the code number is not defined at all,
the mode indicated at the left side of the display toggles between PIN and SCAN.
Example: Code# 30 is only available in SCAN mode. Code# 108 is not defined at all.
To Next Page
Loading...