14 | Using The Lil Buddy December 2008
9. Use the following sequence to drop the windshield into its final position.
• Set the top corner of the windshield into place.
• Move the windshield, as necessary, to position it correctly over the bottom corner.
• Set the bottom corner into place.
10. Place the retention strip or tape from the vehicle roof across the top of the vehicle and
windshield to prevent it slipping while the glue is bonding.
11. Walk around to the other side of the vehicle.
FIGURE 17 - WALK WINDSHIELD INTO POSITION
DO NOT set bottom of windshield first.
Set top of windshield first. Should have
approximately 2 inches of equal clearance.
2 inches
FIGURE 16 - COLLAPSE SLIDING ROD
Hold lower cup in position or
slightly pull toward you.
Push upper cup away from you
to collapse Sliding Rod.
To Next Page
Loading...