Functionality – JUMBO Care with display
Below you find information about what to read-out on the display version of JUMBO Care. Basically the
functionality for the display version is the same as the LED version, but more information can be read out on
the display.
Driving information
As long as a hand control button function is activated, driving information will be shown
on the display. Either lifting arm up, lifting arm down, legs in or legs out or tilt of sling.
The only exception to this is when the battery is flat (stage 3 and 4). At that point the
battery information will be shown instead.
Battery information
The battery discharging will be shown in four stages:
Battery state 1: The battery is ok, no need for charging (100-50%).
Battery state 2: Battery needs charging. (50-25%)
Battery state 3: Battery needs charging. (Less than 25%) Buzzer sound is
provided when a button is pressed in this battery state.
Battery state 4:
(BAJ lead acid)
The battery needs charging. At this stage some of the
functionality of the lift is lost. At this battery stage, it is not
possible to drive the lifting arm up or down. Furthermore, an
audio signal will sound when a control button is activated
(17V or lower). The symbol will switch between the two
pictures for 10 seconds. The battery symbol is shown when
the box is active until power down (2 minutes after use).
Battery state 4:
(BAJ li-ion)
When using CBJ Care with display together with a BAJL
battery, the display will not show the “Battery state 4”
symbol. The BAJL deep discharge protection overrules
the “battery state 4”. Consequently, the CBJ Care shuts
down, and the empty battery symbol is not shown.
The battery level is measured via voltage level. This means that it is possible to experience e.g. that the
battery switches from state 1 to state 2 and back to state 1.
To Next Page
Loading...