Line 6 Firehawk FX User Manual

7. Tap Tempo Button - Pressing the TAP button a few times sets
thetempo,whichDelaysandotherFXthatoer"sync-to-tempo"
canthenfollow.ThefootswitchLEDashesintimetoindicatethe
tempoforthecurrentPreset(theashingbehaviorcanoptionallybe
disabled in the Firehawk Remote app).
Tuner Mode - Press and hold the TAP button for a few seconds to
enter Tuner Mode. When you play a note on your guitar, the Tuner
detects the closest pitch and displays its note value in the LCD
Display. The LEDs on the left side of the Master Volume LED Ring will
lightupwhenyournoteisat,andontherightwhensharp.When
the top center LED is lit, your note is in tune. Touch any footswitch or
knob to exit Tuner Mode.
FLA
T
-5
-1
0+
10
-20
-30
-50
+20
+30
+50
+5
IN TUNE
SHAR
P
IN TUNE
Tuner LED Indicators
8. Expression Pedal - The onboard Expression Pedal can be set to
two dierent Pedal Modes for each Preset: Volume/Wah Mode,
provides control of either the Volume or Wah (toggled using the
pedal's toe switch), and Tweak Mode provides control of the same
Amp or FX parameter that is assigned to the device's FX Knob. You
can optionally connect an Expression Pedal (such as a Line 6 EX-1)
to the PEDAL 2 jack on the rear panel for greater control. Note that
Pedal 2 is automatically detected when connected, and your Pedal
functions change as described below.
Configuring Pedal Functionality
You'llndtheoptionsforPEDAL MODE and RANGE within the Inspector
Pane of the Firehawk Remote app's Editor screen. The current Pedal
Mode is also indicated by the VOL and WAH LEDs at the bottom left of
the pedal.
PEDAL MODE: Thefollowingtableshowsthespeciccontrolfunctions
for the onboard Pedal and Pedal 2 (if a Pedal 2 is connected to the
device) for each Pedal Mode.
PEDAL MODE
ONBOARD PEDAL
FUNCTION
PEDAL 2
FUNCTION
LED
INDICATORS
WAH / VOLUME
No Pedal 2
Wah / Volume
Toe switch toggles Wah or Vol
Not Applicable
WAH or VOL lit
respectively
WAH / VOLUME
With Pedal 2
Wah Only
Toe switch toggles On/Off
Volume Only
WAH lit when
Wah is On
TWEAK
No Pedal 2
Tweak Only
Toe switch has no function
Not Applicable
WAH and VOL
both lit
TWEAK
With Pedal 2
Wah / Volume
Toe switch toggles Wah or Vol
Tweak Only
WAH or VOL lit
respectively
Pedal Mode Functionality
RANGE:TheRangeiscongurablefortheTweak assigned Pedal, and
is also applied to the device's FX Knob. The Range sliders within the
app allow setting Minimum ("heel-down" pedal position) and Maximum
("toe-down" position) values so you can customize exactly how much of
the parameter's range you want to sweep with Pedal 2 and the FX knob.

Line 6 Firehawk FX Specifications

General

Amp Modeling	Yes
Footswitches	5
Looper	No
Tuner	Yes
Bluetooth	Yes
USB	Yes
MIDI	Yes
Expression Pedal	Yes
Power Supply	Included
Presets	128
Effects	Over 200 effects and amp models
Outputs	1/4" outputs, XLR outputs, Headphone output