LineEye LE Series - Page 10

8
Record control Set recording conditions of measured data.
Shortcut key
［
MENU
］
,[3]
Touch the tab or press
、
[SHIFT]+[ ] or [SHIFT]+[ ].
ڦ Additional info.
Idle time :
Select ON/OFF of idle time (non-
communication time) and time
resolution.
Time stamp :
Select ON/OFF of time stamp and
time resolution.
Line state :
Mark on the check box, then status of RTS, CTS, DCD, DTR, DSR, RI and
TRG(trigger input) are recorded along with data.
ڦ Capture buffer :
Recording area :
"BUF0" means full buer. "BUF1/BUF2" means capture buer is divided into
two and use half of them for recording.
Protected :
Prevent data stored in the buer
memory from being inadvertently
overwritten.
Write control :
Select Ring buer (endless
recording) or Full stop when the
capture buer is full.
ڦ Auto save
Set conditions of auto save function to record data in the storage
device.
→[Auto Save Function] (P23)
→[Auto Backup] (P24)
ڦ Auto run
Start measuring automatically at the specic period of time.
→[Auto Run Function] (P24)
Trigger Set the trigger conditions.
→[Trigger Function] (P20)
Wave monitor Set the conditions of logic analyzer function.
→[Timing Waveform Measurement function (Wave Monitor)] (P22)
▲
▲