LineEye LE Series - Page 9

7
Conguration Select basic communication conditions.
Shortcut key
［
MENU
］
,[0]
Protocol :
Select Asynchronous (ASYNC),
Character synchronous (SYNC,
BSC), Bit synchronous (HDLC,
SDLC), I2C or SPI.
Speed
：
Touch [ ] and select the communication speed. It is possible to type any
speed (4 digits) by numerical key. ([C] represents "decimal point". [D]
represents "kilo". [E] represents "mega".

Other settings such as data code, data bit, parity, stop bit need to be set for some protocols.
BCC
：
Select BCC type, begin code and end
Code etc. If selecting transparent
mode,select DLE (Data Link Escape)
code.
Bit sequence :
Select "LSB rst" for normal use.
Frame end time :
Set the time of non-communication
state which is recognized as a frame
end.
Frame end code:
Frame end code can be set up to 2 characters.

Frame end code is necessary to record time stamp.

Necessary settings are dierent in each protocol.

Auto conguration is available (P25).