LH40DA OWNER’S/OPERATOR’S MANUAL18.0
4. DAILY PRE-RIDE INSPECTION
WARNING
You must inspect your ATV each time before riding to ensure it is in
proper working order. If proper inspection is not done, severe injury or
death could result.
Use the following checklist to verify your machine is in proper working
order each time you ride.
ITEM/ INSPECTION PROCEDURE
1, Tire— check condition and pressures.
2, Batteries— check the batteries, charge the batteries to its proper
power.
3, All brakes— check fluid level, check operation, adjustment (includes
parking brake).
● Brake pedal
Check for correct brake pedal free play. If the brake pedal free play is
incorrect, have an authorized dealer adjust it. Check the operation of
the brake pedal. It should move smoothly and there should be a firm
feeling when the brakes are applied. If not, have the vehicle inspected
by your dealer.
● Brake fluid leakage
Check to see if any brake fluid is leaking out of the pipe joints or the
brake fluid reservoir. Apply the brakes firmly for one minute. If there is
any leakage, have the vehicle inspected by an authorized dealer.
Brake fluid level
● Check the brake fluid level.
Add fluid if necessary.
● Brake operation
Test the brakes at slow speed after starting out to make sure they are
working properly. If the brakes do not provide proper braking
performance, inspect the brake system.
4, Throttle/ Accelerator pedal— check for free operation, closing and
freeplay.
Check to see that the accelerator pedal operates correctly. It must
To Next Page
Loading...
