LH40DA OWNER’S/OPERATOR’S MANUAL18.0
4. DAILY PRE-RIDE INSPECTION
operate smoothly and fully spring back to the idle position when
released.
Have an authorized dealer repair as necessary for proper operation.
5, Headlight / Taillight / Brake light— check operation of all indicator
lights and switches.
6, The motor stop switch— check for proper function.
7, Wheels— check for tightness of wheel nuts and axle nuts; check
those axle nuts are secured by cotter pins.
Check balance/ damage/ run out. Have an authorized dealer repair/
replace if necessary.
Check bearing assemblies for looseness/damage. Have an authorized
dealer replace if damaged.
8, Steering— check for free operation noting any unusual looseness in
any area.
Park on level ground. Turn the steering wheel right and left. Check for
excessive free play, abnormal noises, or a rough feeling. Have an
authorized dealer repair as necessary for proper operation.
9, Loose parts— visually inspect vehicle for any damaged components
or loose nuts/bolts or fasteners.
Always check the tightness of chassis fittings and fasteners before a
ride. Take the vehicle to your dealer for correct tightening torque.
10, Operator’s and passenger’s helmets, goggles and clothing.
11, Seat belts— Check for proper operation and belt wear.
Make sure that both seat belts are not frayed or damaged. The seat belt
must move smoothly when pulled out and retract on its own when
released. The latch plate should click securely into the buckle and
release when the release button is pushed firmly. Clean off any dirt or
mud which could affect operation. Have an authorized dealer repair as
necessary for proper operation.
To Next Page