Linhai LH40DA - Rear Gear Case Lubrication Procedure

LH40DA OWNER’S/OPERATOR’S MANUAL 18.0
12. MAINTENANCE
12- 12
Rear Gear case Lubrication
CAUTION
Be sure no foreign material enters the rear gear case.
With the electric UTV on a level surface, remove the fill plug and
visually inspect the lubricant level through the fill hole. Lubricant should
be kept even with the center of the drill point approximately below the
top of the fill hole.
NOTE: Do not add lubricant to the bottom of the fill plug threads. The
correct gear case lubricant to use is SAE GL-4 85W/90 Weight Gear
Lube.
Oil Changing Procedure
1. Remove drain plug. Catch and discard used oil properly.
2. Clean and reinstall the drain plug with a new sealing washer. Torque
drain plug to 11~14 ft. lbs. (15~20N.m)
3. Remove fill plug and add 550ml of SAE GL-4 85W/90 Weight Gear
Lubricant and inspect oil level. Oil level should be kept even with the
center of the drill point (approximately below the top of the fill hole).