Link Communications RLC-3 - 143: Set Offset for RBI-1 or RLC-ICM

14-15
Version 1.77 Copyright © 1997 Link Communications Inc. 8/7/97
143: Set Offset for RBI-1 or RLC-ICM
This command allows you change the offset on the radio connected to the Doug Hall RBI-1. The
offset is always specified as one digit, 0 to 3. There are two different common definitions of what
digit corresponds with what offset. They are shown in the table below. The RLC-3 supports both.
You can select which format you want to use with Command 144.
<143> o
Parameters:
- 143 is the default command name.
- O is the new offset
'O'ffset Format 1 Format 2
0 Minus Minus 20 (1200 only)
1 Plus Minus
2 Simplex Simplex
3 Minus 20 (1200 only) Plus
Note:
You can recall the current band unit, frequency, and offset with Command 149.