2-4
Version 1.77 Copyright © 1997 Link Communications Inc. 8/7/97
000: Connect one Port to another Port
This command allows you to connect one radio port to another radio port. It is also used to put a
port into "repeater mode", by connecting that port to itself. "Connecting a port" means that the
audio in and keying source from each port become the audio out and PTT source for the other
port. Connecting a port to itself makes the audio that comes in your repeater's receiver go out your
repeater's transmitter, making it into a repeater. If you connect two different ports together, they
will hear the activity from the other port.
<000> x y
Parameters:
- 000 is the default command name
- X is the first port to connect
- Y is the second port to connect
Default:
- Port 1 defaults as a repeater
- Ports 2..8 default to links
Note:
C If you want a one-way connection, where port A can monitor port B but port B can not
hear port A, use command 001.
C This command makes the connection both ways. There is no need to enter both “000 12"
and “000 21", for example; either command will make the connection.
Example 1:
Connect Port 1 to Port 4
000 1 4 D or unkey or <Enter>
Response:
Voice Response "1 Connect 4 On"
Example 2:
Want port 3 as a repeater port
000 3 3 D or unkey or <Enter>
Response:
Voice Response "3 Connect 3 On"
To Next Page
Loading...