Link Communications RLC-3 - Chapter 6: CW, DTMF, Voice and DVR Messages

6-1
Version 1.77 Copyright © 1997 Link Communications Inc. 8/7/97
Chapter 6: CW, DTMF, Voice and DVR Messages
This chapter deals with all of the different types of messages that can be sent from the controller:
CW, DTMF, synthesized voice and real voice from the digital voice recorder.
C Sending of CW Messages
- CW speed and tone control
C DTMF regeneration
- Regeneration parameters
C Send a Voice message
C Play, Record and Erase a Digital Voice Recorder message
C Generate one and two tone sequences
C DTMF Keypad test
The controller normally figures out which transmitters each message should go to. Responses to
commands go to the port that executed the command, ID's go to the port that needs them, and
courtesy beeps go to all of the repeaters that could hear the audio from the receiver that caused the
ID. Almost all of these defaults can be overridden by the user, if you so desire. For more
information about how the messages are routed and how you can change the default routing, see
Chapter 16 and Appendix A.