Link Communications RLC-3 - 021: Recall a Timer Value; 022: Start a Timer; 023: Stop a Timer

4-22
Version 1.77 Copyright © 1997 Link Communications Inc. 8/7/97
021: Recall a Timer Value
This command allows you to recall the value of a programmed timer.
<021> xxx
Parameters:
- 021 is the default command name.
- XXX is the selected timer to be programmed (See Command 020 for Timers)
022: Start a Timer
This command makes the specified timer start running, so that it will expire later. If the timer is
already running, this command will make it start over. The controller automatically starts and stops
most timers, but you can override the controller’s normal way of doing things with this command.
You can also use this command to make the user timers start running (timers 64..68).
<022> xxx
Parameters:
- 022 is the default command name.
- XXX is the selected timer to be programmed (See Command 020 for Timers)
023: Stop a Timer
This command allows you to stop a timer, so that it will not expire normally. The controller
automatically stops most timers as needed, so the only time you should need to use this command is
when you want to change the way the controller normally works. Most timers automatically stop
when they expire.
<023> xxx
Parameters:
- 023 is the default command name.
- XXX is the selected timer to be programmed (See Command 020 for Timers)