Link Communications RLC-3 - Page 9

Version 1.77 Copyright © 1997 Link Communications Inc. 8/7/97
Chapter 13: Autopatch Routines .............................................13-1
Configuring the Autopatch: .............................................13-1
Autopatch Up Commands: .............................................13-1
Using '*' for the Autopatch Up Command: .................................13-1
Hanging Up: ........................................................13-2
Connected Ports: ....................................................13-2
Predial Digits: .......................................................13-2
The Autodialer: ......................................................13-2
Limiting Call Length: .................................................13-3
How the Dialing Tables Work: ..........................................13-3
Other Commands that Affect the Autopatch: ................................13-4
110: Configure the Autopatch ..........................................13-6
111: Manual Off Hook ................................................13-7
112: Normal Forward Dial .............................................13-7
113: Forward Dial with no Long Distance Checking .........................13-8
114: Hang up the Autopatch ...........................................13-9
115: Possibly Hang up the Autopatch .....................................13-9
116: Set / Recall the Predial Digits and Timing .............................13-10
119: Set Allowed Numbers Table Slot ...................................13-11
120: Recall Allowed Numbers Table Slot .................................13-11
121: Set Nuisance Numbers Table Slot ..................................13-12
122: Recall Nuisance Numbers Table Slot ................................13-12
123: Test Dialing Tables .............................................13-13
124: Set Autodial Slot ...............................................13-13
125: Recall Autodial Slot .............................................13-14
126: Send Predial Digits / Callsign for Autodial Slot? ........................13-14
127: Enable/Disable an Autodial Slot ....................................13-15
128: Set Full or Half-Duplex Patch Audio for a TX .........................13-15
129: Recall Full or Half-Duplex Patch Audio for a TX .......................13-16
133: Set up Reverse Patch ............................................13-17
134: Access Reverse Patch Control Mode ................................13-18
135: Answer Reverse Patch ...........................................13-18
136: Set up Reverse Autopatch Ring ....................................13-19
137: Autodial Only .................................................13-19
Chapter 14: Doug Hall RBI-1 and RLC-ICM Routines ...........................14-1
What the RBI-1 is: ...................................................14-1
What the RLC-ICM is: ................................................14-1
Interfacing and Setup: .................................................14-1
Using the RBI-1 or RLC-ICM: ..........................................14-2
Building the RBI-1/RLC-ICM Cable ..........................14-5
139: Set Up the RLC-Icom Interface .....................................14-8
RLC-ICM Internal Operation Test Points .................................14-11
140: Set Port for RBI-1 or RLC-ICM ...................................14-12
141: Set Band Unit for RBI-1 or RLC-ICM ...............................14-13
142: Set Frequency (and Offset) for RBI-1 or RLC-ICM .....................14-14
143: Set Offset for RBI-1 or RLC-ICM ..................................14-15
144: Set Offset and Frequency Readback Styles ............................14-16