17
WiFi | Settings | WiFi 2.4GHz
WiFi> Settings>WiFi 2.4GHz
Wireless Settings
Interface Status: Click “Disable” button to disable WiFi, or click “Enable” to activate WiFi
function.
Network Name (SSID): SSID (service set identifier) is a label representing wireless AP. Wireless
clients would see the SSID broadcasted by AP.
Radio Channel: The channel to use. Selecting “Auto” will allow CPE to choose the best channel
automatically.
To avoid the interference , “Radio Channel” will be automatically
changed due to the selected “LTE Band”
Working Mode: There are “802.11axg”, “802.11b/g”, “802.11g/n”, “802.11b”, “802.11g”.
Bandwidth: The setting is only available when the wireless protocol is used; select the
bandwidth from the drop-down list.
• 20M – Set the bandwidth to 20M.
• 40M – Set the bandwidth to 40M.
• 20M/40M – The bandwidth setting will automatically be switched to either 20M or 40M by
CPE based on the environment.
SSID Broadcast: Having SSID broadcast disabled essentially makes your CPE invisible unless a
wireless client already knows the SSID. The default option of SSID Broadcast is “Enabled”.
AP Isolation: Enable or disable AP Isolation feature
To Next Page
Loading...
