7
Installation
Please follow the steps below to install the router:
Step 1. Insert SIM card into the router with instructions shown below until it clicks.
Step 2. Connect one of the LAN ports (any port will do) on the router to your PC with a RJ-45
Ethernet cable provided.
Step 3. Insert the power cord into the DC-12V power jack of the router; and insert the plug into
the power outlet.
Step 4. Switch the power ON. The router will start the booting process. After a few seconds, the
LED lights will start blinking.
Step 5. When the router has booted up, you will see the following LED lights on in solid color: the
WiFi 2.4GHz, WiFi 5GHz, LTE and 5G. You can now connect your device to the router via an
ethernet cable or over WiFi. The network name (SSID) and password (key) can be found on the
label underneath the router.
Note:
1. To remove the SIM card, please press the card in until it clicks and it will pop out automatically.
2. Do not remove the SIM card when the router is operating.
To Next Page
Loading...
Need help?
General
