20
WPS
WPS makes it easy to connect your extender to your network, and connect other devices to your
network through the extender.
Connecting the range extender to an existing access point or wireless router
(see p. 6)
Connecting devices to your network through the range extender
Repeat the instructions for each client device that supports WPS.
1.
Connecting with the WPS Button
a.
Press the WPS button on the client device.
b.
Click the WPS button on the extender’s WPS screen, OR press and hold the WPS
button on the side of the extender for one second. When the connection is complete,
the light on the top of the range extender will be solid green for 20 seconds. If the light
blinks orange for two minutes, the connection failed. Go back to the previous step and
try again.
c.
If using the extender’s WPS screen, be sure to click OK within two minutes or you will
have to start over.
To Next Page
Loading...
Need help?
General
