Linksys RE9000

Manually setting up the Linksys RE9000
In situations where you want to bypass the Linksys RE9000 MU-MIMO Range Extender’s setup
wizard, you can follow the steps below to manually configure the range extender.
NOTE: This article assumes that your Linksys RE9000 is on factory defaults. To reset the Linksys
RE9000, press the Reset button for 5 seconds.
Step 1:
Turn ON the Linksys RE9000 and wait for the light indicator to blink orange.
Step 2:
Using a wireless device, locate and connect to the Linksys Extender Setup Wi-Fi.
Step 3:
Once connected, open a browser and go to http://extender.linksys.com to launch setup.
NOTE: If the Linksys RE9000 has not detected a DHCP server, it defaults to its IP address,
192.168.1.1.
Step 4:
Click the Manual Setup link at the bottom.

Linksys RE9000 Specifications

General

MU-MIMO	Yes
Beamforming	Yes
Wireless Standards	802.11a/b/g/n/ac
Bands	2.4 GHz, 5 GHz
Antennas	4 external
Security	WPA2

Summary

Manually setting up the Linksys RE9000

Setting up the Linksys RE9000 using WPS

Accessing the Linksys RE9000 s web-based setup page

Advanced Configuration

What is 802.11 r?

Explains the proprietary implementation of IEEE 802.11r for Seamless Roaming.

When to enable 802.11 r feature

Recommends enabling 802.11r for networks with Linksys Max-Stream products.

Linksys RE9000 Seamless Roaming Support

Confirms support for Seamless Roaming, improving Wi-Fi signal experience.

Seamless Roaming Guidelines

Outlines requirements for Seamless Roaming to function properly.

How to configure Access Control

Access Mode Options

Explains 'Allow' and 'Deny' modes for controlling Wi-Fi access lists.

Adding Devices to Access Control

Describes methods to add devices via Wireless Client or MAC Address.

Finding the Band Steering Option

Troubleshooting Common Issues

Wi-Fi not detected during setup

Addresses issues with Wi-Fi detection during setup, often related to 5 GHz band.

Using Linksys RE9000 with 2.4 GHz network

Explains using Access Point mode with a 2.4 GHz network via Ethernet.

Extender Setup Wi-Fi list issues

Offers solutions for the setup network not appearing, including proximity and light status.

Password entry errors

Suggests moving the extender closer to resolve password entry errors due to signal issues.

Poor signal or slow speed troubleshooting

Advises placing the extender in an ideal location using Spot Finder technology.

Linksys RE9000 and DFS Channels

Linksys RE9000 Not Detecting Wi-Fi During Setup

Dual-Band Router Requirement

Requirement for a dual-band router for the extender's 5 GHz backhaul connection.

Ensure 5 GHz Band is Active

Ensures the router's 5 GHz band is active for the extender's connection.

Extender Proximity for Setup

Suggests moving the extender closer to the router for initial setup.

DFS Channel Interference

Explains that DFS channels can prevent the extender from detecting the 5 GHz band.

Setting up Linksys RE9000 in Range Extender Mode

Securing Your Range Extender

Setting up Linksys RE9000 in Access Point Mode

Understanding the Linksys RE9000 MU-MIMO Range Extender

Linksys RE9000 Features

Linksys RE9000 Product Requirements