Linksys RE6300

screen (if avaSable), OR press and hold the Wi-Fi Protected Setup bu&on on the
router for one second. When the connection is complete, the Wi-Fi Protected Setup
fight on the extender Wat be solid.
3. If you used the extender’s WI-Fi Protected Setup screen, ~ OK in that screen
within two minutes.
TIP
You can also access W PS in the browser-based utility by clicking WPS in the left
navigation bar.
Connecting with the range extender’s PIN
The Wi Fi Protected Setup PIN (Personal Identification Number) can be found on the
produd label on the back of the extender. You can use this method only if your route~s
administration utiBty has a Wi-Fi Protected Setup menu.
1. Enter the extender~s PIN into the appropriate field on the router~s Wi- Fi Protected Setup
screen. Click Register. When the connection is complete, the Wi-Fi Protected Setup light on the
extender win be send.
2. Click OK Connecting devices to your network through the extender Choose from the methods
below to connect devices that support Wi-Fi Protected Setup
to your network. Delete the screen below
NOTE
Repeat the instructions for each chem device that supports Wi Fi Protected Setup.
Connecting with the Wi-Ff Protected Setup Button
Use this method if your chem device has a WiFi Protected Setup button.
1. Press the Wi Fl ?retooled Setup button on the Ghent device.
2. CliGk the WI-R Protooted Setup button on the extenders WiFl ProteGted Setup
sGfeefi, OR press and hold the Wi-Fi ?retooled Setup bu&on on the side of the
extender for one second When the GOfffleGtfOfl is complete, the Wi-Fi ?retooled
Setup fight on the extender win be scud.
3. If using the extenders WiFl ProteGted Setup sGreefl, be sure to dfGk OKwithifl two
minutes or you will have to start over.
Connecting with the client devices PIN
Use this method if your diefff device has a Wi-Fi ProteGted Setup PIN (Personal
Identification Numbef).
1. Enter the PIN from the client device in the field on the extenders WiFl ProteGted
Setup sGreefl.
2. CliGk Register on the extenders WI-Fi ProteGted Setup sGreefl. When the GonrfeGflon is
complete, the Wi-Fi Protected Setup light on the extender will be solid.
3. CliGk OK on the extender~s Wi-Fi ?retooled Setup sGfeefi within two minutes or you
will have to start over.
Connecting with the extendeYs PIN
Use this method if your client device asks for the extenders PIN
1. On the client device , enter the PIN listed on the extender~s Wi-Fi ?retooled Setup
sGfeefi. (It is also Bsted on the product label on the back d the exteflder.) When the
GonrfeGflon is complete, the Wi-Fi Protected Setup light on the extender will be solid.
2. CliGk OK on the extender~s Wi-Fi ?retooled Setup sGfeefi within two minutes.
How to use Site Survey
Site Survey gives a snapshot of aH neighboring access points and wireless routers
within range of the extender.