Linksys RE6700

Frequently
Asked Questions
Why can I not find "Linksys
Extender
Setup-
XXX"
in my Wi-Fi list?
Make sure
the
indicator
LED on
the
range extender is
blinking amber.
If
you
still
can't
see
the
setup
network,
move
the
device being used
for
setup
closer
to
the
range
extender. Wait
for
a
blinking
amber LED and refresh
the
Wi-Fi
list.
On
browser-based setup, why do
I
not see
the
setup
screen
on
http://extender.linksys.com?
On
your device's Wi-Fi manager, make sure "Linksys
Extender
Setup-
XXX" is
selected,
then refresh your browser.
On
browser-based setup, why can
I
not
see my
network
name
on
the
"Choose
your
wireless"
page?
Your
range extender might be too far from the router. Move
it
closer and refresh the list.
I
correctly
entered
my
network
password during browser-based setup. Why
does
the
"Enter
your
password"
page still show an error?
The range extender
likely
is
at
the
outside
limit
of
the
router's
signal. The
signal could
be
getting
interrupted
before your password makes
it
to
the
router. Move your range
extender
closer
to
the
router
and
let
Spot
Finder Technology help
you
find
the
ideal
location.
The
further
you are
from
the
area
in
Spot
Finder Technology labeled
"Just
Right"
the
more likely you are
to
have issues
with
your
network
password.
Why can't
I
connect my range
extender
with WPS?
There are a number
of
reasons
that
WPS
could fail:
• Your
router
and range extender are
too
far
apart
•
The
two-minute
connection window expired
•
The WPS
button
on either range extender
or
router
did
not
depress
all
the
way
•
WPS is
disabled
on
the
router
• MAC filtering
is
enabled
on
the
router
How do
I
reset
the
range
extender
to
factory
defaults?
Using a paperclip
or
safety
pin, press the reset button on
the
side
of
the
range
extender and
hold until the indicator LED
starts
blinking
green.
Why am I
experiencing poor signal
and
slow speed
on
my range
extender?
Be
sure
that
you've
placed
your range extender in
an
ideal location,
as indicated by
Spot Finder Technology.
NOTE: When you move around your home, your wireless
devices may
not
disconnect from the router until
they
lose
the
Wi-Fi
signal.
This
may
occur even
if
the Wi-Fi
signal
from the range extender
signal
is stronger (and vice
versa).
If
you are having connection issues, select
the network
with
the stronger
signal.
How do
I access my range
extender
settings
after
setup?
To
change
or
view your range extender settings, go
to
your device's Wi-Fi manager and
connect
to
your extended network.
In
a browser, go
to
http
://extender.linksys.com and
enter your ad min password.
For advanced configuration
consult
user guide
at
linksys.com/support/re6700.
8820-02193
Rev.
COO