WIRELESS
REGULATORY
INFORMATION
FCC
Statement
This
device
complies
with
Part
15
of
the
FCC
Rules.
Operation
is
subject to
the
following two conditions:
(1)
This
device
may
not
cause
harmful
interference,
and
(2)
this
device
must accept
any
interference
received,
including
interference that
may
cause
undesired
operation.
This
product
has
been
tested
and
complies
with
the
specifications for a
Class
B digital
device,
pursuant to
Part
15
of
the
FCC
Rules.
These
limits
are
designed
to
provide
reasonable
protection against harmful interference
in
a residential installation.
This
equipment
generates,
uses,
and
can
radiate
radio
frequency
energy
and,
if not installed
and
used
according to
the
instructions,
may
cause
harmful
interference to
radio
communications.
However,
there
is
no
guarantee
that interference
will
not occur
in
a particular installation. If this
equipment
does
cause
harmful interference to
radio
or
television
reception,
which
is
found
by
turning
the
equipment off
and
on,
the
user
is
encouraged
to
try to correct
the
interference
by
one
or
more
of
the
following
measures:
• Reorient
or
relocate the receiving
antenna
•
Increase
the separation between the equipment
and
devices
• Connect the equipment to
an
outlet other than the receiver's
• Consult a dealer
or
an
experienced radio/TV technician for assistance
FCC
Caution:
Any
changes
or
modifications not expressly
approved
by
the
party
responsible
for
compliance
could
void
the
user's
authority to operate
this
equipment.
IEEE
802.11b
or
802.11g operation of this product
in
the
USA
is
firmware-limited to
channels
1 through 11.
The
device
for the
band
5150-5250
MHz
is
only
for indoor
usage
to
reduce
the
potential for
harmful
interference to
co-channel
mobile
satellite
systems.
FCC
Radiation
Exposure
Statement
This
equipment
complies
with
FCC
radiation
exposure
limits set forth for
an
uncontrolled
environment.
This
equipment
should
be
installed
and
operated
with
minimum
distance
32
em
between
the
radiator
and
your
body.
This
device
and
it's
antennas(s)
must
not
be
co-located
or
operating
in
conjunction with
any
other
antenna
or
transmitter except
in
accordance
with
FCC
multi-transmitter product
procedures.
Industry
Canada
Statement
CAN
ICES-3
(B)/NMB-3
(B)
This
device
complies
with Industry
Canada
license-exempt
RSS
standard(s).
Operation
is
subject to
the
following two conditions:
(1)
this
device
may
not
cause
interference,
and
(2)
this
device
must accept
any
interference, including interference that
may
cause
undesired
operation of
the
device.
For
product
available
in
the
USA/Canada
market,
only
channel1-11
can
be
operated.
Selection of other
channels
is
not
possible.
To Next Page
Loading...
