Linksys SPA1001 - Page 184

Index
IN-8
Linksys ATA Administrator Guide
Document Version 3.01
Remove Last Reg 5-11
Reorder Delay 5-23
Reorder Tone 5-19
repetition, in dial plans 3-7
resetting
factory defaults
2-21
Restricted Access Domains parameter 5-8
Restrict Source IP 5-37, 5-52
Resync URL 3-3
Retry Reg RSC 5-14
Ring1/2/3/4/5/6/7/8 Caller parameter 5-68, 5-70
Ring1 Cadence 5-21
Ring1 Name 5-22
Ring2 Cadence 5-21
Ring2 Name 5-22
Ring3 Cadence 5-21
Ring3 Name 5-22
Ring4 Cadence 5-21
Ring4 Name 5-22
Ring5 Cadence 5-21
Ring5 Name 5-22
Ring6 Cadence 5-21
Ring6 Name 5-22
Ring7 Cadence 5-21
Ring7 Name 5-22
Ring8 Cadence 5-21
Ring8 Name 5-22
Ring Back Tone 5-20
Ringer Impedance parameter 5-64
Ring Frequency 5-23
Ring Frequency Max parameter 5-64
Ring Frequency Min parameter 5-64
Ring Indication Delay parameter 5-64
Ring On No New VM parameter 5-69
Ring Threshold parameter 5-64
Ring Timeout parameter 5-64
Ring Validation Time parameter 5-64
Ring Voltage 5-23
Ring Waveform 5-23
RTCP Tx Interval 5-15
RTP Bytes Recv parameter 5-3
RTP Bytes Sent parameter 5-3
RTP CoS Value 5-35, 5-50
RTP Log Intvl parameter 5-37, 5-52
RTP Packet Size 5-14
RTP Packets Recv parameter 5-3
RTP Packets Sent parameter 5-3
RTP Port Max 5-14
RTP Port Min 5-14
RTP ToS/DiffServ Value 5-35, 5-50
rules
dial plans
3-6
S
SAS DLG Refresh Intvl 5-34
SAS Enable 5-34
SAS Inbound RTP Sink 5-34
saving configuration 3-19
Secondary DNS parameter 5-2, 5-9
Secondary NTP Server parameter 5-9
Second Dial Tone 5-19
Secure All Call Act Code 5-27
Secure Call Indication Tone 5-20
Secure Call Serv parameter 5-42
Secure Call Setting parameter 5-67
Secure No Call Act Code 5-27
Secure One Call Act Code 5-27
Secure One Call Deact Code 5-27
secure provisioning 3-4
Send Resp To Src Port 5-17
sequences, dial plan 3-5
Service Annc Base Number 5-28
Service Annc Extension Codes 5-28
Service Announcement Serv parameter 5-42
Session Initiation Protocol 1-10
set
multicast address
2-20