Linksys SPA1001

3-14
Linksys ATA Administrator Guide
Document Version 3.1
Chapter 3 Configuring Linksys ATAs
Configuring a Streaming Audio Server
If the Linksys ATA boots and finds that the SAS line is on-hook, it will not remove battery from the line
so that IVR may be used. But if the Linksys ATA boots up and finds that the SAS line is off-hook, it will
remove battery from the line because no audio session is in progress.
Example SAS with MOH
Figure 1-15 MOH Application with a Linksys ATA Line Configured as an SAS
The following configuration examples are based on the configuration shown in Figure 1-15.
SAS Line Registered with the Proxy Server
In this example, the SAS Line is registered with the Proxy Server as the other subscribers.
On
Linksys ATA 1:
SAS Enable[1] = no
MOH Server [1] = 1002
SAS Enable[2] = yes
On Linksys ATA 2:
SAS Enable[1] = no
MOH Server [1] = 1002
SAS Enable[2] = no
MOH Server [2] = 1002
SAS Line Not Registered with the Proxy Server
In this example, the SAS Line is not registered with the Proxy Server for the other subscribers.
On
Linksys ATA 1:
IP Network
Phone 1
Phone 2
Phone 1
Phone 2
Media
signal
adapter
SPA1:
IP=192.168.2.100
UserID[1]=1001, SIP Port[1]=5060
UserID[1]=1002, SIP Port[1]=5061
SPA2:
IP=192.168.2.200
UserID[1]=2001, SIP Port[1]=5060
UserID[1]=2002, SIP Port[1]=5061
Line in
Music
source