Linksys SPA1001

3-9
Linksys ATA Administrator Guide
Document Version 3.1
Chapter 3 Configuring Linksys ATAs
Configuring a Dial Plan
Dial Plan Timers
The dial plan functionality is regulated by the following configurable parameters:
• Interdigit_Long_Timer
• Interdigit_Short_Timer
• Dial_Plan ([1] and [2])
Interdigit Long Timer
The <Interdigit_Long_Timer> specifies the default maximum time (in seconds) allowed between dialed
digits, when no candidate digit sequence is as yet complete (see the discussion of the Dial_Plan
parameter for an explanation of candidate digit sequences).
Interdigit Short Timer
The <Interdigit_Short_Timer> specifies the default maximum time (in seconds) allowed between dialed
digits, when at least one candidate digit sequence is complete as dialed (see the following discussion of
Dial_Plan parameters for an explanation of candidate digit sequences).
Dial Plans
The Dial_Plan parameters contain the actual dial plan scripts for each line n, where n is a number from
1 to 4.
ParName Interdigit_Long_Timer
Default 10
ParName Interdigit_Short_Timer
Default 3
ParName Dial_Plan[n] for Each Line n
Default
(*xx | [3469]11 | 0 | 00 | <:1408>[2-9]xxxxxx |
1[2-9]xx[2-9]xxxxxx | 011x. )