6-56
Linksys SPA9000 Administrator Guide
Document Version 3.01
Chapter 6 SPA9000 Field Reference
Line 1/2/3/4 Tab
VMSP Bridge Applies only if this line interface offers voice mail services. It specifies whether the
SPA9000 should bridge the call from an external caller on the same or a different line
interface. The choices are:
• None—Do not bridge external calls from any line interfaces
• All—Bridge external calls from any line interfaces except from the same line
• All+Self—Bridge external calls from any line interfaces including the same line
Notes:
• If the external call is also on this line interface, the SPA9000 does not attempt to
bridge the call even if the value is All.
• If <PBX Network Interface> is WAN, <Force Media Proxy> must be yes for VMSP
Bridging to function properly.
The default is None.
CFWD Bridge Mode Instructs the SPA9000 how to handle call forwarding of an external caller to another
external number by a client station. This parameter was added in Release 5.1.
The normal way of performing this operation is for the SPA9000 to send a (blind) SIP
REFER to the calling device to let it contact the target number directly. It then drops out
of the call completely. This requires the calling device to understand the SIP signaling
involved and the operation permitted by the underlying service provider. The SPA400, for
instance, cannot handle this operation.
With bridging, the SPA9000 maintains two separate call legs throughout the call: one with
the caller and one with the call forward target. The two call peers connect only with the
SPA9000, while the SPA9000 acts as a proxy for the RTP packets exchanged between the
two parties.
This parameter has two possible values:
• None—Do not bridge forwarded calls (use the normal REFER method)
• All—Bridge all forwarded calls
The default is None.
Field Description
To Next Page
Loading...
