3-16
Linksys SPA9000 Administrator Guide
Document Version 3.01
Chapter 3 Configuring Voice Service and Voicemail
Configuring the SPA400 for PSTN Connectivity or Voicemail
Figure 3-17 SPA400 Administration Web Server—Setup/Voicemail Server Page
Step 2 In the Server Port field, enter the UDP port over which the Voicemail Server listens for signaling
between the SPA400 and the SPA9000.
In Figure 3-17, the value of this field is 5090.
Note This port number must be different from the UDP port configured in the SPA9000 Interface
menu.
Step 3 Enter the User ID that the SPA9000 uses to register the SPA400 voicemail server.
This setting must be identical to the User ID configured in the SPA400 SPA9000 Interface page. In the
example, this value is SPA9000.
Step 4 In the SPA9000 subscriber ID field, enter the Subscriber ID that the SPA9000 uses to subscribe to the
SPA400 voicemail server for obtaining notification.
Step 5 In the Mailbox deposit number field, enter the associated telephone number that the SPA9000 uses to
deposit voicemail.
Step 6 In the Mailbox manage number field, enter the associated telephone number that the SPA9000 uses to
access voicemail.
Step 7 Click Save Settings at the bottom of the page and then the Restart button on the SPA400 administration
web server.
The SPA400 device reboots.
Configuring the SPA9000 Voicemail Settings
You must match the parameters entered in the SPA400 Voicemail Server fields in the SPA9000
administration web server under the associated Line # used for the SPA400 voicemail server.
The example assumes the SPA9000 is configured to use Line 1. The configuration and installation of
the SPA400 and the integrated voicemail application server can be configured on the same SPA9000
Line tab.
To Next Page
Loading...
