2-20
Linksys SPA9000 Administrator Guide
Document Version 3.01
Chapter 2 Getting Started
Initial Setup and Configuration
Step 4 Select one of the following types of devices to upgrade:
• SPA941/921
• SPA942/922
• SPA962
• SPA901
• SPA9000
• SPA400
Step 5 Click Next.
Step 6 The system displays Page 2 of the Software Upgrade Wizard (see Figure 2-14
Figure 2-14 Software Upgrade Wizard—Page 2
Step 7 Type the IP address of the device you are upgrading and enter the Administrator account password, if
this is set.
1. To determine the IP address of a SPA92x or 94x phone, press the Menu button,
2. Scroll down to Network and press the left button (Select).
3. Note the Current IP address, and enter it into Page 2 of the Software Upgrade wizard.
To determine the IP address of a SPA901 phone, pickup the handset, press ****, followed by 110#.
Step 8 Click Next on Page 2 of the Software Upgrade wizard.
Figure 2-15 illustrates the Upgrade Prompt that appears.
Figure 2-15 Upgrade Prompt
Step 9 Click OK to confirm the upgrade operation.
To Next Page
Loading...
