Linksys SPA922

Linksys SPA9x2 Phone Administration Guide 62
Sample Configuration File
Provisioning Basics
4-
General Purpose Parameters
The following table defines the function and usage of each parameter in the General Purpose
Parameters section of the Provisioning tab.
• GPP_A through GPP_P: General purpose provisioning parameters. These parameter can
be used as variables in provisioning and upgrade rules. They are referenced by
prepending the variable name with a ‘$’ character, such as $GPP_A.
You can optionally Require Admin Password to Reset Unit to Factory Defaults (see last line of
sample config file).
Sample Configuration File
Following is a sample configuration file:
Set_Local_Date_(mm/dd) "" ;
Set_Local_Time_(HH/mm) "" ;
Time_Zone "GMT-07:00" ; # options: GMT-12:00/GMT-11:00/GMT-10:00/GMT-09:00/GMT-08:00/GMT-07:00/GMT-06:00/GMT-
05:00/GMT-04:00/GMT-03:30/GMT-03:00/GMT-02:00/GMT-01:00/GMT/GMT+01:00/GMT+02:00/GMT+03:00/GMT+03:30/
GMT+04:00/GMT+05:00/GMT+05:30/GMT+05:45/GMT+06:00/GMT+06:30/GMT+07:00/GMT+08:00/GMT+09:00/GMT+09:30/
GMT+10:00/GMT+11:00/GMT+12:00/GMT+13:00
FXS_Port_Impedance "600" ; # options: 600/900/600+2.16uF/900+2.16uF/270+750||150nF/220+820||120nF/220+820||115nF/
370+620||310nF
FXS_Port_Input_Gain "-3" ;
FXS_Port_Output_Gain "-3" ;
DTMF_Playback_Level "-16" ;
DTMF_Playback_Length ".1" ;
Detect_ABCD "Yes" ;
Playback_ABCD "Yes" ;
Caller_ID_Method "Bellcore(N.Amer,China)" ; # options: Bellcore(N.Amer,China)/DTMF(Finland,Sweden)/DTMF(Denmark)/ETSI
DTMF/ETSI DTMF With PR/ETSI DTMF After Ring/ETSI FSK/ETSI FSK With PR(UK)
FXS_Port_Power_Limit "3" ; # options: 1/2/3/4/5/6/7/8
Protect_IVR_FactoryReset “No” ;
Note that you can optionally require an admin password to reset the phone to factory defaults
by setting the last line parameter to “yes.”
If you are a service provider with a password, see the Linksys SPA Provisioning Guide.