Wireless Network Access Point
1. At the Windows XP desktop, click Start. Then click the Control Panel
icon. Click Network and Internet Connections. Click Network
Connections. Then double-click the appropriate Local Area Connection,
and click the Properties button.
2. If the TCP/IP Protocol is listed for your network adapter, go to step five.
Otherwise, click the Install button.
3. Select Protocol, and then click the Add button.
4. Select Internet Protocol (TCP/IP) from the list, and click the OK button.
5. Select TCP/IP, and click the Properties button.
6. Select Use the following IP Address.
7. Enter an IP address for the computer, along with a Subnet mask and Default
gateway address. Then, click the OK button. If you do not have these val-
ues, consult your network administrator.
8. When you’re finished, click the Close button. Restart your computer.
TCP/IP has now been successfully installed.
39
Instant Wireless
®
Series
1. At the Windows 2000 desktop, right-click My Network Places. Then,
right-click Local Area Connection. Choose Properties.
2. If the TCP/IP Protocol is listed for your network adapter, go to step five.
Otherwise, click the Install button.
3. When the Component Type window appears, select Protocol, and click the
Install button.
4. Select Internet Protocol (TCP/IP) from the list, and click the OK button.
5. When the Network window reappears, select TCP/IP, and click the
Properties button.
6. Select Use the following IP Address.
7. Enter an IP Address for the computer, along with a Subnet Mask and
Default Gateway. Then, click the OK button. If you do not have these val-
ues, consult your network administrator.
8. When the Network window reappears, click the OK button. Restart your
computer. TCP/IP has now been successfully installed.
38
TCP/IP Setup for Windows XPTCP/IP Setup for Windows 2000
To Next Page
Loading...
