Cleaning
Risk of electric shock!
WARNING!
Moisture in the device may cause a short circuit or electric shock.
- Before cleaning, remove the mains plug from the mains power
socket.
- Do not immerse the device in water or other liquids.
- Make sure that no water or other liquid gets inside the housing.
-
After cleaning, carefully dry the device before using it again.
Risk of damage!
NOTE!
Improper handling can damage the device.
- Do not use any harsh cleaning products, brushes with metal or
nylon bristles, or sharp or metallic cleaning materials such as
knives, hard scrapers or similar. They can damage the surfaces.
-
Never wash the device in the dishwasher. This would destroy
the device.
1. Before cleaning, remove the mains plug from the mains power socket.
2. Allow the device to completely cool down.
3. Wipe the device and the accessories with a slightly damp cloth. Then allow all parts
to dry completely.
Decalcify
If you operate the device with tap water, regular descaling is necessary. This should
ideally be done after 10 fillings.
1. Unscrew the tank cap
4 from the water tank 5 counterclockwise.
2. Fill the water tank with a solution of 75 % water and 25 % pure white vinegar using
the funnel 11 and the measuring cup 10 .
3. Plug the mains plug into a socket.
4. Leave the water tank open and press the ON/OFF switch 2.
5. Wait until the solution in the tank starts to boil.
63
To Next Page
Loading...