Extension tubes
The extension tubes 15 are designed to reach e.g. high points. They can be attached to
all accessories by means of the two adapters included in the delivery.
- Insert the two extension tubes into each other so that they snap into place.
The extension tubes are plugged together.
- Press the release device and pull the two extension tubes apart.
The extension tubes are separated from each other.
Adapter with nozzle
The adapter with nozzle 18 is designed for deep cleaning of e.g. sink, gas cooker and
other places where tough dirt accumulates.
- Attach the adapter with nozzle to the pistol (see chapter Attach accessories).
The adapter with nozzle is attached.
Disconnecting the accessories
- To disconnect the accessories, follow the assembly steps in reverse order (see
section "Selecting and mounting accessories").
Draining the device
Risk of scalding!
WARNING!
The device is very hot after use.
- Let the device cool down after use before you empty it.
1. Pull the mains plug out of the socket.
2. Let the device cool down completely.
3. Press the steam switch
6 on the pistol 7 to release the residual pressure from the
device.
Direct the steam jet into a suitable container.
4. Remove the tank cap 4.
5. Turn the device over and let the water drain out of the water tank.
The device is emptied.
62
To Next Page
Loading...