Refilling the water tank
Risk of scalding!
WARNING!
If the device is still hot, the water could splash up when refilling.
- Refill the water slowly and carefully.
If no more steam comes out during operation, the water tank is empty and must be
refilled.
1. Switch off the device by pressing the on/off switch 2.
2. Pull the mains plug out of the socket.
3. Let the device cool down for approx. 5 minutes.
4. Press the steam switch 6 on the pistol 7 to release the residual pressure from the
device.
Direct the steam jet into a suitable container.
5. Refill the water tank (see chapter Filling the water tank).
Switching off
1. Press the on/off switch 2.
2. Pull the mains plug out of the socket.
The device is switched off.
Accessories
Take out accessories
Parts of the accessories are stored in the accessory compartment and can
be taken out or stored if necessary.
1. Open the accessory compartment 8 upwards.
2. Take out or store the required accessories.
3. Close the accessory compartment.
Selecting and mounting accessories
Connect the accessories listed below to the adapter with nozzle 18, unless
otherwise specified.
60
To Next Page
Loading...