Appendix A: If the printer complains
Linx 5900 & 7900 Quick Start Guide 62 FA69315–3 English
3.13 Cover Override Link
Fitted
Contact your local Linx distributor.
3.14 Power Off Override
Active
Contact your local Linx distributor.
3.15 Safety Override Active Contact your local Linx distributor.
3.16 Gutter Override Active Contact your local Linx distributor.
3.17 Gate Array Test Mode
Active
Contact your local Linx distributor.
3.18 Low Pressure Contact your local Linx distributor.
3.19 Valid UNIC Chip Not
Found
Contact your local Linx distributor.
3.20 No Time of Flight
Clean the printhead. Perform a Nozzle Flush and/or Nozzle Clear.
If the failure persists, contact your local Linx distributor.
3.21 Ink Low Prevented Mix Refill the ink tank with ink.
3.22 Fault Prevented Mix
7900 Spectrum printers only.
This will be accompanied by another event message, describing the
fault. If the fault is listed in this section, perform the necessary action.
If the fault is not listed here, consult your supervisor or local Linx
distributor.
3.23 Power Off Occurred
During Mix
7900 Spectrum printers only.
Wait until the printer finishes the mix sequence before you power off
the printer. (During a mix sequence, the printer status is shown as
“MIX”.)
3.24 Restart In Progress
Press the OK key to acknowledge the event message. The printer
should operate normally.
3.25 Ink Unmixed for 4
Weeks
7900 Spectrum printers only.
Wait until the printer finishes the mix sequence before you start to
print. (During a mix sequence, the printer status is shown as “MIX”.)
3.26 User Data Corrupt Contact your local Linx distributor.
3.27 Mix Disabled Contact your local Linx distributor.
3.28 Printhead requires
cleaning at shutdown
Clean the printhead after the next shutdown. If the failure persists,
contact your local Linx distributor.
3.29 Over Speed (No
Remote Data)
Contact your local Linx distributor.
3.30 Remote Error Contact your local Linx distributor.
3.31 Restarted Print Delay Contact your local Linx distributor.
3.35 Printer Requires
Scheduled Maintenance
Within One Month
The printer is due for a service within the next month. Contact your
local Linx distributor to arrange for a scheduled maintenance visit.
Event Message Action
Figure A-1. System Events (Continued)