Chapter 2: Get started
FA69315–3 English 13 Linx 5900 & 7900 Quick Start Guide
2 Get started
Have you read all the details in ‘Before you start’? Are you confident that
you understand all the Safety information? If so, you can now begin to use
the printer, with the help of the instructions in this chapter.
By following the instructions you learn how to turn on the printer, and how
to create and print a message. Also, you learn how to pause the print, stop
the jet, and turn off the printer.
The printer system should already be unpacked, installed and set up by a
Linx approved Service Engineer. The mains power supply should already
be connected.
WARNING: IF THE PRINTER IS NOT ALREADY CONNECTED AND
YOU ARE IN ANY DOUBT AS TO YOUR ABILITY TO CONNECT
POWER TO THE PRINTER, CONTACT YOUR SUPERVISOR FOR
GUIDANCE.
2.1 Turn on
To turn on the printer:
1. Set the mains power supply switch at the rear of the printer to the
on (I) position, as shown in Figure 2-1:
Figure 2-1. Mains Power Supply Switch on the rear panel
2. Press and hold the button on the front of the printer until the green
power LED on the control panel illuminates. This LED shows that the
printer is turned on.
3. Wait until the printer power-up is complete. The splash screen (see
page 6) shows the progress of the power-up process.
49145
To Next Page
Loading...
Need help?
General
