LION Alcolmeter 700 - Error Messages and Warnings; Fatal Error Messages; Error Code Messages

lion alcolmeter® 700 User Handbook (Ref: RM79009)(ver: 2)
Page 34
Warning messages
Fatal error messages
If a fatal message is shown, the lion alcolmeter® 700 automatically powers
down and cannot be used until the appropriate remedial action has been
taken. The most likely occurring examples of such a message are:
Instrument too hot
Instrument too cold
Change battery
Error code messages
The Error code X messages are explained in the following table. If any of
these occur, please contact service personnel for attention.
lion alcolmeter
©
700: Error Code Messages
Code
Meaning/Significance
2
Fuel cell amplifier signal is too high
3
Fuel cell output too low during instrument calibration
4
Gas flow rate applied during breath flow sensor calibration too low
5
Charge pump did not generate the required voltage
6
Temperature below -6°C
7
Calibration or checking attempted below 15°C
8
Calibration or checking attempted above 30°C
16
Fuel cell offset voltage has drifted too low
17
Blockage in sampling system
18
Used in Factory Mode only
19
Used in Factory Mode only
23
False peak