20
TrainMaster Command operations
Reprogramming R2LC circuit boards to restore features
STEP 1: Move switch on locomotive from
run to program.
STEP 2: Turn on Command Base.
STEP 3: Place locomotive on track, then
turn on power to track.
STEP 4: Press “ENG” then input locomo-
tive’s ID#. Press “SET”
STEP 5: Press “ENG”, then the ID#,
“AUX1”, then press 6 for your locomotive.
STEP 6: Turn off power to track, wait ten
seconds.
STEP 7: Remove locomotive from track,
move switch from program to run.
STEP 8: Place locomotive back on track,
turn power on to track.
STEP 9: Press “ENG” and ID#, then oper-
ate as normal.
D
ue to the inevitable derailments, stat-
ic, and the negative nature of electrici-
ty, it is possible that your R2LC could some-
day lose its setup program.The symptoms of
this condition would be unresponsiveness
in command mode. This can be easily
remedied by “reprogramming” your R2LC
using the following steps.
To program your R2LC as a diesel locomotive with cab
light, follow these steps. (These steps will also restore pro-
gramming which is accidentally lost due to static,
numerous derailments, etc.)
Note!
To Next Page
Loading...
