Lippert Components Power Gear

Questions and Answers

C
Crystal BrownJul 28, 2025
What to do if Lippert Components Lifting Systems touch pad will not turn on?
- C
  cortezwilliamJul 29, 2025
  If the touch pad on your Lippert Components Lifting System isn't turning on, there are a few potential causes. First, ensure the coach ignition is in the run position and the engine is running, as the jacks require it to operate. Also check for a blown fuse or tripped circuit breaker and replace or reset it if necessary. Finally, the system may have auto shut off; try pushing the On/Off button to turn the control back on.
M
Matthew NicholsAug 7, 2025
Why Lippert Components Power Gear jacks will not extend and pump is not running?
- F
  fernandezbrianAug 7, 2025
  If your Lippert Components Lifting Systems jacks aren't extending and the pump isn't running, it could be due to a blown fuse or tripped circuit breaker; replace the fuse or reset the breaker. Another possible cause is weak batteries. Turn on the ignition and start the coach, allowing a few minutes for the batteries to charge, as the engine must be running for the jacks to operate.
J
Jason PerkinsAug 16, 2025
What to do if Lippert Components Lifting Systems jacks will not extend (or are extending slowly), but the pump is running?
- J
  Jessica LeeAug 16, 2025
  If your Lippert Components Lifting Systems jacks aren't extending properly (or are extending slowly) but the pump is running, check the fluid level. If it's low, fill the tank to the correct level using automatic transmission fluid. Weak batteries may also cause this issue. Turn on the ignition and start the coach, allowing a few minutes for the batteries to charge, as the engine needs to be running for the jacks to operate.