11
lippert.com 432-LIPPERT (432-547-7378) Rev. 09.29.23
JT’s Strong Arm
™
Installation and Owner’s Manual
(For Aftermarket Applications)
CCD-0001455
Operation
1. Level your trailer side-to-side.
2. Lower the front of the trailer ¾” lower than the rear.
3. Lower and set rear jacks evenly.
4. Tighten the T-Bolts on the two rear Strong Arm
Jack Stabilizers.
5. Raise the front of the trailer to make it level front-
to-rear.
6. Tighten T-Bolts on the four front Strong Arm
Jack Stabilizers.
7.
slightly lift the front of the trailer. This eliminates the
play (movement) at the bolts and bolt holes between the
stabilizers and the trailer.
Maintenance
Periodically wash the strong arms with water to remove
any salt or debris. Then wipe dry with a clean, dry cloth.
Apply Labels
2. Place Warning Label in any available location that is
visible while operating electric leveling jack switch.
A. Clean mounting surface thoroughly.
B. Remove backing from label and adhere to mounting
surface using a squeegee or similar tool.
Hydraulic Jack Adapter Lugs
This is an optional kit to be used when installing JT’s
Strong Arm to units with hydraulic jacks.
Resources Required
• Cordless or electric drill or
screw gun
• Appropriate drive bits
• Appropriate drill bits
• Bolts
• Liquid thread locker
• Non-permanent marking
device
Parts List
Hydraulic Jack Adapter Lugs (314592)
Letter Part # Description Qty
A 196233 Hydraulic Jack Adapter Lugs 2
B
427963 Screw 2
A
B
NOTE: For most applications,3 kits (6 lugs) will be
necessary unless repairing/reinstalling an individual
footpad.
Preparation
Prior to installation, prepare surface of footpad for lug
Footpad Number of Lugs
Front 2
Rear 1
To Next Page
Loading...
