6
lippert.com 432-LIPPERT (432-547-7378) Rev. 09.29.23
JT’s Strong Arm
™
Installation and Owner’s Manual
(For Aftermarket Applications)
CCD-0001455
REMOVE PERSONAL PROPERTY AND VALUABLES
FROM THE CENTER COMPARTMENT TO PREVENT
POSSIBLE DAMAGE OCCURRING DURING
DRILLING.
I. Tighten nuts enough to ensure needing a screwdriver
for leverage to pivot swing bolts.
E.
2. Go to Front To Rear Bracket Installation.
Option 4 - Fig. 2
1. From the inside of one of the front jacks, measure toward
the center of the center compartment 30” and place a 2”
mark ¼” from the front edge of the compartment.
A.
mounting holes.
B.
pad ¼” from the front edge of the compartment.
C.
pads on the bottom of the center compartment, then
center-punch the marks.
D. To prevent accidental damage to personal property,
clear the center compartment of any valuables.
E. ⁄”
⁄” mounting holes. Use a countersink bit to deburr the
inside of the holes.
F.
G. Secure the two pads using a ⁄” - 16 x 1 ¼” swing bolt,
a ⁄” x 1 ½” bolt, ⁄” washers and ⁄” - 16 nylon locking
nuts.
H. The swing bolts should be inserted into the mounting
holes located closest to the electric jacks.
I. Tighten nuts enough to ensure needing a screwdriver
for leverage to pivot swing bolts.
J. Repeat steps 1-1I for the other jack.
2. Go to Front To Rear Bracket Installation.
Option 5 - Fig. 3
1. Insert a ⁄” - 16 x 1 ¼” swing bolt into a spacer mount and
secure with a ⁄” washer and ⁄” - 16 nylon locking nut.
A. From the inside of both front jacks, measure toward
the center of the cross-member 27 ¾” and place a mark.
Align one of the short edges of the spacer mount with
the mark keeping the swing bolt toward the center of
the chassis.
B. Mark the center of the mounting holes, then center
punch the holes.
C. ⁄” pilot holes at the four mounting hole locations,
then re-drill the holes located closest to the electric jacks
to ⁄” on both sides of chassis.
D. Tap the ⁄” holes with either a ⁄” - 16 tap or a ⁄” - 16
x 1” self-tapping bolt. Lubricate tap as needed.
E. Remove tap or bolt and secure spacer mount with
a ⁄” - 16 x 1” self-tapping bolt, taking care to keep the
remaining pilot hole centered in the mounting hole of the
spacer mount. Tighten bolt securely.
F. ⁄” and insert a ⁄” - 16 x 1”
self-tapping bolt and tighten.
G. Repeat steps 1-1F on opposite side of chassis.
2. Go to Front To Rear Bracket Installation.
Fig.3
To Next Page
Loading...
