Lippert Unity X4 User Manual

Rev: 05.06.23 Page 17 CCD-0007005
Reverse Polarity Outputs
1. Press UNKNOWN at Momentary H-Bridge #1 (Fig. 41A) to begin programming reversing outputs.
2. Press UNKNOWN under TYPE and select device type (Fig. 42).
NOTE: If more than one device type of the same name is used, press INSTANCE (Fig. 44C) to select a
number, e.g. Bedroom Slide 1, Bedroom Slide 2, etc.
3. Press UNKNOWN under NAME to select device name (Fig. 43) and press SET (Fig. 43A) so Saved!
appears in the lower left of the DEVICE NAME field (Fig. 44A).
4. Press the field under FUSE to select fuse type and press SET so the selection is saved (Fig. 44B).
Fig. 41
Fig. 42
Fig. 43 Fig. 44
A
A
B
C
A

Lippert Unity X4 Specifications

General

Brand	Lippert
Model	Unity X4
Category	Control Unit
Language	English