To Next PageTo Next Page
Need help?Do you have a question about the liquidarc Maxmig 210i and is the answer not in the manual?
General| Input Power | 230 V, 50/60 Hz |
|---|---|
| Output Current | 210A |
| Duty Cycle | 60% @ 210 A |
| Wire Diameter | 0.6-1.0 mm |
| Electrode Diameter | 1.6-4.0 mm |
| Output Current Range | 30-210 A |
| Efficiency | 85% |
| Power Factor | 0.73 |
| Insulation Class | F |
| Protection Class | IP21S |
| Wire Feed Speed Range | 2-15 m/min |
Safety measures for electric shock, fumes, and gases during welding.
Precautions for gas cylinders and protection from arc rays.
Preventing fires from sparks and managing EMF exposure, including pacemakers.
Instructions and methods for managing electromagnetic compatibility in welding.
Procedures for locating, connecting to mains, and setting up gas supply.
Connecting the gun and cable, and setting the correct output polarity.
Overview of power switch, pilot light, voltage, and wire speed controls.
Using duty cycle, spot welding, gas purge, wire inch, and 2T/4T operation.
Changing electrode size and adjusting spool tension for proper feeding.
Maintaining the gun and avoiding wire feeding problems.
Step-by-step guide for performing arc welding using the machine.
Procedures for electrical ground testing and replacing internal circuit boards.
Settings for wire burnback time and motor acceleration rate.
Common problems and solutions for welding issues and machine faults.
Detailed parts lists and wiring diagrams for the Maxmig 210i model.
Detailed parts lists and wiring diagrams for the Maxmig 210R model.
Details on warranty period, conditions, exclusions, and limitations of liability.
