LR-3200 Receiver Manual 17
My battery is not charging
Verify the clear plastic pull tab has been removed from the receiver battery door engaging the battery
connections. Make sure the battery is installed properly and that the unit is plugged into the charging device
correctly. Check the charging device to verify it is plugged in the proper power outlet and power is available
at the outlet. If this does not work, install a replacement battery.
I want to run the unit from a wall transformer
Simply plug a Listen approved charging transformer (LA-421) into the Micro USB connector on the side of the
unit. A battery must be installed at all times even when operating the unit with a wall charging transformer.
COMPLIANCE NOTICE AND FCC STATEMENT AND INDUSTRY
CANADA STATEMENTS
Compliance Notice
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) These devices may not cause harmful interference, and (2) these devices must accept any interference
received, including interference that may cause undesirable operation.
FCC Statement
This equipment has been tested and found to comply with the limits for a class B digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment o and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This equipment has been certied to comply with the limits for a class B computing device, pursuant to FCC
and IC Rules. In order to maintain compliance with FCC and IC regulations, shielded cables must be used
with this equipment. Operation with non-approved equipment or unshielded cables is likely to result in
interference to radio and TV reception. The user is cautioned that changes and modications made to the
equipment without the approval of manufacturer could void the user’s authority to operate this equipment.
Industry Canada Statement
This equipment complies with ICES-003 class B.
CAN ICES-3 (B)/NMB-3(B)
To Next Page
Loading...