HIRO BUGGY Stroller for Special Needs Children Revision 2 Page 15
Fig. 16
After unzipping sides there is possibility to roll and hatch back upholstery above zippers, and pin it with rubber bands with
pins.
7.7 Upper strap fastener adjustment
The stroller is equipped with three-point straps (1) allowing the child to be appropriately secured. The straps offer adjustable
height of the upper fasteners and adjustable strap length.
The height of the upper strap fasteners is determined based on the height of the child’s shoulders. The fasteners should be
located slightly above the shoulders, so that the child is not pushed downwards when the straps are tightened. The adjustment is
made by loosening the knobs (2) located at the back of the backrest. After setting the fasteners at the desired height, tighten the
knobs (2).
Fig. 17
The straps are equipped with plastic grommets for strap length adjustment. Their position needs to be adapted to the
child’s body posture. In order to change the location of the strap buckle (3), readjust the strap attached in the plastic part of the
seat under the upholstery.
To Next Page
Loading...