To Next PageTo Next Page
Need help?Do you have a question about the LMI Technologies Liquitron DP5000-1A and is the answer not in the manual?
General| Brand | LMI Technologies |
|---|---|
| Model | Liquitron DP5000-1A |
| Category | Controller |
| Language | English |
Details on mounting the control module, including required clearances for stability.
Explains connecting the control module to a power outlet and various components.
Details the function of each terminal pin on Terminal Blocks TB1, TB2, TB3, and TB4.
Provides instructions for connecting pumps, probes, switches, and optional boards.
Explains the function of each key on the Liquitron DP5000 keypad.
Describes the default ON/OFF and Proportional control modes of the controller.
Details how to program set points and pump speeds for Proportional control.
Explains how to set pH set points and hysteresis for ON/OFF control.
Instructions for programming high/low alarm points and alarm hysteresis.
Instructions for viewing previous calibration results.
Guides for performing a new single or two-point pH calibration.
How to set pump run times and solenoid valve delay/ON times.
Details on setting pump run times for Pump A and Pump B.
Instructions for setting Delay 1 and Delay 2 timers for solenoid valve control.
Access and configuration of advanced controller settings.
Discusses the pH electrode as a replaceable part and reasons for failure.
Lists and explains common error messages displayed by the controller.
