LMS 1A Series - Quick Programming Guide

3.11
Quick Programming Guide
DUAL TEMPERATURE CYCLING WITH LIGHTS ON
In this program we will set the first temperature at 25ºC for a period of twelve hours
with the lights on and the second temperature of 15ºC for a period of twelve hours with
the lights off. This program will also run continuously.
Press and hold both ▲ and ▼ buttons for 3 seconds
Display will read LEUL
P
Press ▲ button, display reads Prog
Add
Press ▲ button until display reads Stu
Pu
Press and hold * and press ▲, display reads Stu
SP
Press ▲ button until display reads SEG
Add
Press ▲ button until display reads type
SPR
Press and hold * and press ▲ button until display reads type
Step
Press ▲ button until display reads t.SP
0.0 (current Set temp.)
Press and hold * and press either ▲ or ▼ button until set-point is reached
25ºC
Press ▲ button until display reads EOP
3D
Press and hold * and press ▲ until display reads EOP
3E
Press ▲ button, display reads SEG
1
Press and hold * and press ▲ button, display reads SEG
Add
18 of 31
01/12