Section 4
OPTIONAL EXTRAS WHERE FITTED
ALL NON PROGRAMMABLE MODELS
Control Panel
4.0 INTERIOR ILLUMINATION
The interior illumination in these models is either controlled by the programmable
controller, a 24 hour timer or 7 day timer depending on the item fitted to the control
panel.
Where no timer is fitted the controller will need to be programmed for temperature,
time and lights on/off. Please refer to Section 3 or the quick programming guide.
Models fitted with a 24 hour or 7 day time clock, require the segments to be
adjusted, by pulling outwards or pushing in according to requirements. Each small
segment represents 10 minutes on a 24 hour clock and 1 hour on a 7 day clock.
To set the time initially, the clock hands should be turned clockwise only.
Warning: Do Not Turn Hands Anti-Clockwise, as this may damage the clock
When internal illumination switches on during the course of a cycle a slight rise in
cabinet air temperature may be experienced. Where shelf lights are fitted, the rise
will be more pronounced.
To Next Page
Loading...
Need help?
General
